http://www.nrx-china.com/productsd.php?pid=21&tid=7
- Load up RemoteCapture.ino and plug a 433.92MHz receiver to digital pin 2.
- Open up Tools -> Serial Monitor in Arduino IDE and start pressing the remote controller (button).
- Copy paste the 41 bit commands to Axel.ino for sendAxelCommand(). A minimum of two different codes is required.
- Set the extension cord into pairing mode 5097 by holding down its power button until the LED starts blinking.
- Send a command, eg. "sendAxelCommand(AXEL_TOGGLE_1);", which stops the pairing mode.
- Now you can control the cord by sending alternating commands to it. E.g. sendAxelCommand(AXEL_TOGGLE_1); (or AXEL_TOGGLE_2).