My remix of the tantillus, a cross gantry printer from 2012.
This version uses a frame printed in a single piece, a mosquito/NF Crazy and Vz Hextrudort on top t
60CE
o bring it to a more recent standard.
The fishing lines have also been swapped over to GT2 Belts for better quality and uses a 2:1 gear ratio on the stepper to the motion components.
The travel is about 108mm on X, 109mm on Y and 143mm on Z, printable volume is about 100x100x140mm.
The body of the printer requires a 207x200x295mm print so beware before starting this project, the short version only requires a 207x200x250mm printer but the Z axis travel is reduced to 100mm.
Assembly Video:
@Glizzynator. on discord
-PCB for the breakout board by Lhndo
-Original Tantillus by Intrinsically-Sublime
-VZ hextrudort by the vzbot team
-Side blowers by Cbon123
This work is licensed under a Creative Commons (4.0 International License)
Attribution—Noncommercial—Share Alike