Peak Starplex Guitar Dismantle Instructions
This is for the PlayStation 2 Peak Starplex Guitar.
Included is an STL file to 3d print the battery cover.
-
Take the black screw cover off the back [fig01 and fig02] (between the battery compartment and the metal plate) and remove the screw inside with a CR-V PH2.
-
Remove the battery cover. [fig03]
-
Unscrew the 8 screws on the battery cover. [fig04]
-
Slowly lift the guitar as the white strum unit will fall out. [fig05] [fig06]
-
Remove the metal plate. [fig07]
-
TAKE EXTRA CARE to slowly lift the guitar up from the fret board. The fret board ribbon cables are EXTREMELY fragile. [fig08]
-
Check the ribbon cables are still intact. [fig09]
Getting it back on
-
Start by putting the metal plate on the back and screw the 4 large screws through so that they are just through the other side. Line up the fret board and slide it down into the guitar lining up with the screws. This will stop it from moving as you start to screw.
-
Using the 4 slightly pointed screws, put the batter cover on making sure the hole for the on/off switch is in the correct place and screw in the 4 OUTER screws.
-
Put the strum unit in and screw in the 4 flat bottom screws.
-
Screw in the long screw in the back and put the screw cover on.