CMoy
 | This article may contain excessive or inappropriate references to self-published sources. (September 2020) |
A CMoy is a pocket headphone amplifier originally designed by Pow Chu Moy.[1][2]
The headphone amplifier is designed around single or dual-channel operational amplifiers (op-amps) such as Burr-Brown's OPA2134 or OPA2132PA, however, a wide variety of op-amps have been successfully implemented. As the op-amp directly drives headphones, some care should be given when choosing an op-amp. Some op-amps are not suitable for such low impedance loads and will result in poor performance.[3][4][5] (See Op-amp swapping.)
The amplifier's design is quite simple. It consists of only a few components, can be assembled on a small section of protoboard, has a lower parts cost than other headphone amplifiers, and can run for many hours on a single 9 volt battery.[6]
Circuit
A typical CMoy consists of two identical AC coupled, non-inverting operational amplifier circuits each with a 100kΩ input impedance.
Power is supplied to the opamps using a dual power supply, which effectively divides the input voltage source in half to create a virtual ground. Many virtual ground circuit options are presented in the various CMoy tutorials found online.
References
- ^ Hertsens, Tyll (March 15, 2016), A Memorial to the Grandfather of Headphone Enthusiasm, archived from the original on March 5, 2018, retrieved March 5, 2018
- ^ Moy, Chu. "A Pocket Headphone Amplifier". headwize.com. Archived from the original on 2015-04-15.
- ^ Northwest Audio & Video Guy (August 10, 2011), Op Amps: Myths & Facts
- ^ Großklaß, Stephan (2014-07-15), A Classic Hi-Fi Misconception
- ^ Young, Warren (October 31, 2016), "Notes on Audio Op-Amps", Audiologica
- ^ Rutter, Daniel (20 March 2004). "Review: Chu Moy headphone amplifier". Dans Data. Retrieved 2009-06-03.